Thank you for using our V200 Tour guide system. The transmitters and receivers are already delivered fully charged and set to the same channel in one or more groups based on your request. They are also delivered clean and sanitized as this is our standard policy.
Just press the power button
and you’re good to go!
Meanwhile, right below you can find some simple instructions regarding their functions, which are useful to read before using the system.
- First, turn transmitter ON by pressing the “
” button. Also use the same button to turn ON the receivers you wish to connect. - On the transmitter ,keep pressed “+ and -” buttons on the together for 5 seconds. The antenna symbol disappears.
- Now use “+ or -” button to select the desired channel.
- Long press the “” button until channel number starts blinking. At this step the trasmitter sends new channel to the receivers. Allow 10 seconds for all receivers to connect and press “” briefly. You have succesfully connected the receivers !
The receiver in this image is in search mode, which is why a magnifying glass appears on the screen. At this point, it hasn’t established a connection to the transmitter yet.
The receiver in this image has successfully established a connection with the transmitter, therefore an antenna signal reception sign has replaced the magnifier lens sign.
Receivers and transmitters are delivered inside a carrying case which also acts as a charging station. Charging will take up to 5 hours for all units (in case they are totally discharged). Furthermore, each device is equipped with a common USB Type-C port, which means you can use a standard phone charger or power bank to charge the devices if needed.
You can confirm the end of charging when the battery sign on the screens is static and no longer blinking. Please note that none of the units will be operational while charging.
When full charging is complete, it will provide receivers 30 hours of operation and respectively for the transmitters 10-12 hours
The receivers can be turned off with three ways.
1.By long pressing the “” button
2. Remotely from the transmitter. By long pressing the “-” (minus symbol) on the transmitter for 10 seconds and then the pressing“” button briefly.
3. In case the transmitter turns off , the receivers will also turn off 20 minutes later in order to save battery.
ANC : Active noise cancelling. Each time you press this button, the noise cancelling effect increases. Default level is 1 line and max level is 4. We suggest leaving in default (1 line). In case of tour in noisy environments, you can try out using it on level 2 or 3. Level 4 uses aggressive noise cancelling and thus it may cut out your voice also.
: On /Off button. Hold pressed to power the unit on & off.
: Mute button. Press it to mute your microphone if needed. When pressed, you will notice that the antenna icon is replaced by an microphone icon.
+ and – buttons: Channel selection as described previously , as well as remotely turning off all receivers by long-pressing the “–” minus button.
: Volume down & 
Volume up buttons ( Hold pressed )
: On /Off button. Hold pressed to power the unit on & off.
Sovereign Event Systems
Always something New!